• FormulaMod Official Store 0
    Cart Total: items

    Your cart is currently empty..

Bykski

45° GPU Water Block Replacement Bridge – Bykski B-VGA-RET-W

stars, based on ( 0 ) review
€14.00 piece
items available
Contact Us
FormulaMod Official Store
Bykski · B-VGA-RET-W

45° replacement bridge for GPU water blocks

The Bykski B-VGA-RET-W replaces the original terminal on a compatible Bykski GPU water block. The clear acrylic bridge puts both G1/4 ports at a 45° angle, so you can route tubing from the water block at an angle. Check your exact water block model before ordering.

Fits
Compatible Bykski GPU water blocks
Port angle
45°
Port thread
G1/4
Material
Clear acrylic

Fits / Use With

For compatible Bykski GPU water blocks with a removable stock terminal.

Before ordering, confirm that your exact water block model accepts B-VGA-RET-W and that its terminal mounting holes match.

Use G1/4 fittings on the bridge.

Key Specifications

Part numberB-VGA-RET-W
Part typeReplacement terminal bridge
MaterialClear PMMA (acrylic)
Port orientation45°
Port threadG1/4
Bykski B-VGA-RET-W clear acrylic bridge viewed from the side, showing both angled ports

What's in the Box

1 × B-VGA-RET-W clear replacement bridge

Installation & Use

1
Switch off the system and drain the loop. Disconnect the tubing and remove the original terminal.
2
Seat the seals in the grooves on the underside of the replacement bridge.
3
Align the bridge with the water block’s mounting holes and secure it with the correct screws.
4
Reconnect the tubing, refill the loop, and run only the pump to check for leaks before powering the system.

FAQ

What does the 45° angle refer to?

It describes the direction of the two fitting ports on the replacement bridge.

Can I use my G1/4 fittings?

Yes. Both ports take G1/4 fittings.

What part of the water block does it replace?

This bridge replaces the original terminal on a matching Bykski GPU water block.

FormulaMod Official Store

Recent Reviews
+