Bykski
Hard Tube Bending Tutorial for PMMA and PETG Tubing | Bykski
stars, based on ( 0 ) review
FormulaMod Official Store
Bykski · Video Tutorial
How to Bend Hard Tubing for PC Water Cooling
This Bykski video tutorial introduces hard tube bending for custom PC water cooling. The written guide below explains how to shape PMMA acrylic or PETG tubing to fit your loop. Choose a silicone insert by the tube’s inner diameter so it supports the wall as the tubing softens. This page is for viewing the tutorial.
Materials
PMMA acrylic and PETG
Heat source
Heat gun
Bending insert
Sized by tube inner diameter
Tutorial at a Glance
| Application | Hard tubing for custom PC water cooling loops |
|---|---|
| Tube materials | PMMA (acrylic) and PETG |
| Silicone insert fit | Choose by tube inner diameter (ID) |
| Fitting and bending form fit | Check against tube outer diameter (OD) |
Tools You’ll Need
Heat gunSilicone bending insertBending formTube cutting and deburring tools
How to Bend the Tube
1
Slide a snug silicone insert into the tube so it supports the section you plan to bend.
2
Rotate the tube while heating the bend area with a heat gun, until the tube starts to soften.
3
Bend the tube smoothly around the form and hold it in shape until it firms up.
4
Remove the insert, trim the tube to its final length, and deburr the cut ends.
FAQ
Can you reheat hard tubing if the bend is off?
Corsair’s XT Hardline guide says reheating can correct a bend to a limited extent and advises against the practice.
What heat gun setting should I use?
Heating intensity and timing depend on the heat gun. Rotate the tube as you heat it and watch for it to start bending under its own weight.
How do I choose a silicone insert?
Use the tube’s inner diameter to choose an insert that fits snugly. The insert supports the wall and helps reduce kinks as you bend the tube.
Notes
- Do not purchase this link, only for viewing the tutorial video







