Bykski B-VGA-XS15-X L-type acrylic bridge module, suitable for GPU water blocks, transparent, reduces GPU water block height by 11mm, G1/4 inlet/outlet direction conversion adapter.

Bykski B-VGA-XS15-X L-Type Acrylic Bridge Module for GPU Water Blocks, PMMA Transparent 4-Port G1/4 Inlet/Outlet Direction Conversion Adapter

TL;DR: The B-VGA-XS15-X is a transparent PMMA L-shaped bridge module that retrofits GPU water blocks to reroute the inlet and outlet ports through the side of the card. Four standard G1/4 threaded ports are arranged so coolant can enter from the top or back and exit from the side, freeing clearance...

Common Applications

The B-VGA-XS15-X is a transparent PMMA L-shaped bridge module that retrofits GPU water blocks to reroute the inlet and outlet ports through the side of the card. Four standard G1/4 threaded ports are arranged so coolant can enter from the top or back and exit from the side, freeing clearance against the chassis side panel in compact builds. Only two of the four ports are used at a time, so stop fittings (not bundled) are required on the unused ports to seal the loop. Mounting hardware consists of M4 x 24mm screws and pre-cut sealing O-rings.

Frequently Asked Questions

Q: What does the B-VGA-XS15-X do?

A: It is an L-shaped PMMA bridge module that changes the direction of the inlet and outlet ports on compatible GPU water blocks, routing the loop through the side instead of the top.

Q: How many ports are on the bridge and what thread does it use?

A: Four ports total, all standard G1/4 thread. Only two ports are used in operation; the remaining two must be sealed with stop fittings.

Q: What is included in the box?

A: One bridge block, sealing O-rings, and M4 x 24mm mounting screws. Stop fittings are not included and must be purchased separately.

Q: Which GPU water blocks does it fit?

A: It is designed to retrofit GPU water blocks that share the matching screw pattern and port pitch. Confirm hole spacing on the target block before ordering.

Q: Why use a side-port bridge instead of the standard top bridge?

A: In narrow cases the top fittings can collide with the side panel. Routing the loop sideways through this bridge clears the panel and shortens the tube run.