Barrow Hard Tube Bending Kit for 12/14/16mm OD Rigid Tubing, with 45°/90°/180° Molds, Silicone Insert, Grinding Tool and Cutter

Barrow Hard Tube Bending Kit for 12/14/16mm OD Rigid Tubing, with 45°/90°/180° Molds, Silicone Insert, Grinding Tool and Cutter

TL;DR: This Barrow kit is the full bending-tool set for a hardline water-cooling build. Each variant is sized to one OD: 12mm, 14mm or 16mm. The kit contains a 45° mold, a 90° mold and a 180° mold, an ID-matched silicone tube that is pushed inside the rigid tubing to stop the wall collapsing during the ben

Common Applications

This Barrow kit is the full bending-tool set for a hardline water-cooling build. Each variant is sized to one OD: 12mm, 14mm or 16mm. The kit contains a 45° mold, a 90° mold and a 180° mold, an ID-matched silicone tube that is pushed inside the rigid tubing to stop the wall collapsing during the bend, a grinding tool to clean up the cut end, and a cutter for trimming tubing to length. Workflow: heat the rigid tube with a heat gun, then press it into the corresponding mold to set the angle.

Frequently Asked Questions

Q: Which tube outer diameters does this kit fit?

A: The kit is sold in three OD variants: 12mm, 14mm and 16mm. Each variant ships with a silicone insert sized to the inner diameter of that tube.

Q: What is in the box?

A: One 45° mold, one 90° mold, one 180° mold, one silicone insert tube, one grinding tool and one cutter.

Q: How is the kit used?

A: Heat the rigid tube first with a heat gun, then press it into the mold of the desired angle. Do not heat the mold directly.

Q: Can the included cutter be used on acrylic tubing?

A: Not recommended. The included cutter is not strong enough for acrylic, so acrylic tube should be cut with a different tool.