• FormulaMod Official Store 0
    Cart Total: items

    Your cart is currently empty..

Bykski

4U Server CPU Liquid Cooler, 360 mm, Single or Dual CPU | Bykski B-FRD-SR-360

stars, based on ( 0 ) review
items available
Contact Us
FormulaMod Official Store
Bykski · B-FRD-SR-360

360 mm AIO liquid cooling for 4U server CPUs

The Bykski B-FRD-SR-360 is an all-in-one CPU liquid cooler for 4U servers with room to mount a 360 mm-class radiator. The loop carries heat from the CPU blocks to the fan-cooled radiator. Choose the version that matches your motherboard socket and the number of CPUs you need to cool.

Fits
Supported 4U server builds
Radiator class
360 mm
Configurations
Single or dual CPU

Compatibility

Select your motherboard’s socket. Each option is available in single-CPU and dual-CPU configurations.

  • ✓Intel LGA4189
  • ✓Intel LGA4677
  • ✓Phytium Tengyun S5000C-64 (select LGA5796)
  • ✓AMD SP3 (select LGASP3)
  • ✓AMD SP5 (select LGASP5)

Verify the cooler mounting layout on your motherboard before ordering. For Intel builds, check which processor carrier your platform requires.

Key Specifications

Product familyBykski B-FRD-SR-360
Cooling typeAll-in-one CPU liquid cooler
Radiator360 mm class, aluminum
Radiator length397 mm end to end in Bykski’s single-CPU drawings
Radiator fans3
CPU block baseT2 copper
Pump layoutInline pump
TubingBraided EPDM
Bykski dual-CPU cooler with two connected CPU blocks and an upright three-fan radiator

Dual-CPU configuration shown.

What's in the Box

1 × 360 mm-class radiator3 × radiator fans1 × inline pump with tubing1 or 2 × CPU blocks, depending on selection

For Intel LGA4189, use the thermal interface material specified for your platform. Intel advises against thermal grease for this socket. The paste instruction below applies only to platforms that specify paste.

Thermal paste is not included (it cannot be shipped by air). Please use your own thermal paste during installation.

Installation & Use

1
Shut down and disconnect the server. Remove the existing CPU cooler following the server’s service instructions.
2
Check radiator and tube clearance, then secure the radiator and fans at the chassis mounting points.
3
Clean off old thermal interface material. Apply your own thermal paste where specified by the CPU platform, or use the thermal interface material it calls for. Secure each block in the prescribed mounting sequence.
4
Connect the pump and fans following the cooler and server documentation. Verify that both are running at first power-on.

FAQ

Will this fit any 4U server chassis?

Check the radiator mounting points and available space in your chassis. Bykski’s single-CPU drawings show a radiator length of 397 mm end to end.

Does the dual-CPU version use a separate cooler for each CPU?

The dual-CPU version uses two CPU blocks on one loop with a shared radiator.

Notes
  • Confirm the space behind the radiator for the fan stack and check that the tubing reaches the CPU mounting position without kinking.

FormulaMod Official Store

Recent Reviews
+