Bykski
Digital Water Pressure Gauge for PC Cooling — Bykski B-PRE-SC-V2, G1/4 OLED
Digital pressure gauge for custom PC water cooling
The Bykski B-PRE-SC-V2 is an inline digital pressure gauge for custom PC water-cooling loops. Its built-in OLED shows the current coolant pressure in hectopascals (hPa) and displays short-term changes so you can follow pressure while the loop is running. It connects between two fittings in the coolant line.
Fits & Use With
For custom PC water-cooling loops with G1/4 male tubing fittings.
For the hard-tube setup shown below, choose fittings that match your tubing’s outside diameter. Allow room for the fittings and tubing at both ends.
Design Highlights
Read pressure as the loop runs
The OLED shows the current reading in hPa. A bar shows how pressure changed over a 12-second interval.
Threaded ports at both ends
Each end has a G1/4 female port. The manufacturer’s hard-tube setup uses one tube fitting on each side of the gauge.
Key Specifications
| Model | B-PRE-SC-V2 |
|---|---|
| Housing | Black POM |
| Front panel | Glass |
| Display | OLED |
| Pressure unit | hPa (hectopascals) |
| Ports | 2 × G1/4 female |
| Body size (L × D × H) | 65 × 35 × 32 mm |
Pressure Gauge, Flow Meter, or Leak Tester?
Included gauge
Installation & Use
For this setup, you’ll need two G1/4 male hard-tube fittings sized for your tubing, plus tubing and coolant for the loop.
FAQ
What does the pressure gauge measure?
It reads coolant pressure as your custom PC loop runs. The OLED reports the reading in hPa.
What fittings do I need for hard tubing?
Use two G1/4 male hard-tube fittings sized for the outside diameter of your tubing.
What appears on the OLED at startup?
The startup logo gives way to a live reading after about five seconds. A bar shows pressure changes over a 12-second interval.
How much room does the gauge need?
The body is 65 mm long, 35 mm deep, and 32 mm tall. Leave room for a fitting and tubing at each end.
- Not responsible for any hardware damage. Use at your own risk.











