Bykski
Iluvatar CoreX TianGai 150 (BI-V150) AIO Liquid Cooler, Bykski B-FRD-BIV150
All-in-one liquid cooling for the Iluvatar BI-V150
The Bykski B-FRD-BIV150 is an all-in-one liquid cooler for the 64 GB Iluvatar CoreX TianGai 150 (BI-V150) PCIe accelerator with the BIV150 PCB. It replaces the stock passive heatsink with a full-cover water block. In the standard 360 mm kit, an inline pump circulates coolant to a fan-cooled radiator mounted in the case.
Compatibility
- ✓Iluvatar CoreX TianGai 150 (BI-V150), PCIe, 64 GB HBM2e, BIV150 PCB layout
Before ordering, compare your card’s PCB and mounting holes with the board shown here.
Design Highlights
Pump in the tubing
On the standard B-FRD-BIV150-360, the inline pump circulates coolant through braided tubing between the GPU block and the radiator. Radiator fans move air through the fins to carry heat out of the loop.
Full-cover metal block
The T2 copper cold plate follows the BIV150 board layout. Bykski’s installation diagram shows where to apply paste to the chips and place pads over the power components.
Parallel microchannels
Bykski specifies up to 44 parallel 0.3 mm microchannels in the cold plate to increase the surface area in contact with coolant.
Key Specifications
| Model | Bykski B-FRD-BIV150 |
|---|---|
| Cooling type | Full-cover GPU AIO |
| Block construction | All-metal block with T2 copper cold plate |
| Block dimensions | 278.19 × 106.68 × 16.60 mm |
| Standard radiator mount | 360 mm |
| Pump (standard 360 mm) | Bykski’s illustrated spec: 7,000 RPM, 450 L/h flow, 7 m head |
| Stock card form factor | Full-length, full-height, dual-slot PCIe |
| Stock card board power | 350 W |
Which Version Do I Need?
This page offers two 360 mm options. Choose by card count and radiator clearance.
For a custom loop, see the Bykski IC-BIV150-SR water block with backplate for the TianGai 150.
What’s in the Box
Thermal paste is not included (it cannot be shipped by air). Please use your own GPU thermal paste during installation.
Installation & Use
You’ll also need your own GPU thermal paste, a screwdriver, and a case with room for the accelerator, radiator, fans, and tubing.
FAQ
How is the Iluvatar BI-V150 cooled from the factory?
The BI-V150 uses a passive heatsink that relies on chassis airflow. The AIO replaces that heatsink and moves heat to a radiator with fans.
Where is the pump on the standard 360 mm AIO?
The pump sits in the tubing between the GPU block and the radiator.
Will the standard 360 mm kit fit my case?
Look for a 360 mm radiator mount. Compare the case’s available space with the radiator’s overall length and the depth with fans installed, and allow room for the tubing to bend.
What does the -H suffix mean on this listing?
B-FRD-BIV150-360-H is the 360 mm thick-radiator option listed for two cards. Check the available mounting depth before choosing it.
- If the block does not sit flat or the screw holes do not line up, stop and check the PCB layout before tightening.













