Bykski CC-HR-X / CC-HR-10/15/20/25-X Offset Fitting, G1/4 Male-to-Female 360 Rotary Adapter, CNC Brass, 6/10/15/20/25mm

Bykski CC-HR-X / CC-HR-10/15/20/25-X Offset Fitting, G1/4 Male-to-Female 360 Rotary Adapter, CNC Brass, 6/10/15/20/25mm

TL;DR: The CC-HR series is a family of G1/4 male-to-female offset adapters that shift the outlet axis laterally so two ports that do not line up can still be plumbed in hardline. The base CC-HR-X offsets the outlet by 6mm, with CC-HR-10-X, CC-HR-15-X, CC-HR-20-X and CC-HR-25-X stepping the offset up to...

Common Applications

The CC-HR series is a family of G1/4 male-to-female offset adapters that shift the outlet axis laterally so two ports that do not line up can still be plumbed in hardline. The base CC-HR-X offsets the outlet by 6mm, with CC-HR-10-X, CC-HR-15-X, CC-HR-20-X and CC-HR-25-X stepping the offset up to 10, 15, 20 and 25mm respectively. Bodies are CNC machined from brass with a polished surface finish and sealed by an EPDM-grade rubber O-ring. The adapter rotates a full 360 degrees around its own axis after installation, so the offset direction can be set without breaking the seal. The 15-25mm sizes use a supported double-bearing body to keep the offset rigid under hardline tube stress.

Frequently Asked Questions

Q: What offset sizes are in the series?

A: 6mm (CC-HR-X), 10mm, 15mm, 20mm and 25mm offsets, each as a separate SKU.

Q: Does the fitting rotate after installation?

A: Yes, 360 degrees around its axis, so the offset direction can be set after tightening.

Q: What thread does it use?

A: G1/4 inch BSP, male on one side and female on the other.

Q: What is the body material?

A: CNC machined brass with surface treatment and a rubber O-ring seal.

Q: Are the larger sizes still single-piece?

A: The 15, 20 and 25mm variants use a supported double-bearing construction to keep the offset rigid under tube load.