Barrow
Barrow LD2RT-50 / LD2RT-100 LRC 2.0 5V 3-Pin Self-Adhesive Trimmable Addressable RGB LED Strip (50cm / 100cm)
Barrow LD2RT-50 / LD2RT-100 LRC 2.0 5V 3-Pin Self-Adhesive Trimmable Addressable RGB LED Strip (50cm / 100cm)
TL;DR: The LD2RT-50 and LD2RT-100 are flexible addressable RGB LED strips with self-adhesive backing in 50cm and 100cm lengths. They use the Barrow LRC 2.0 5V 3-pin standard, which is electrically equivalent to common 5V ARGB headers, so the strip will sync with motherboard ARGB software when connected to...
Common Applications
The LD2RT-50 and LD2RT-100 are flexible addressable RGB LED strips with self-adhesive backing in 50cm and 100cm lengths. They use the Barrow LRC 2.0 5V 3-pin standard, which is electrically equivalent to common 5V ARGB headers, so the strip will sync with motherboard ARGB software when connected to a 5V 3-pin header or a Barrow LRC 2.0 controller. The strip is trimmable at the marked cut intervals along the length and can be routed around reservoirs, radiator frames, distribution plates, or case edges. Each detachable IC section runs independently so up to several hundred preset and reactive lighting effects are available through compatible controller software. A controller is not bundled and must be added separately or replaced by a motherboard 5V ARGB header.
Frequently Asked Questions
Q: What signal protocol does the LD2RT use?
A: 5V 3-pin addressable RGB (Barrow LRC 2.0). It is wire-compatible with common 5V ARGB motherboard headers. Do not connect it to a 12V 4-pin RGB header - the LED ICs will burn out.
Q: Can the strip be cut to length?
A: Yes. Cut only at the marked cut lines along the strip. Cutting between segments breaks the addressable chain for the trimmed-off portion.
Q: Is a controller included?
A: No. Use a Barrow LRC 2.0 controller or any motherboard 5V 3-pin ARGB header. The strip is sold without a controller.
Q: How long are the two SKUs?
A: LD2RT-50 is 50cm long; LD2RT-100 is 100cm long. Both are self-adhesive on the back face.
Q: Is it waterproof?
A: The strip is built with a sealed coating suitable for reservoir-side and case-internal use, but it is not rated for submerged or long-term wet operation.
