Barrow SPD10-T DC12V 10W PWM Integrated Pump and Reservoir Combo, 450L/H Flow, 3m Head, G1/4 Ports, 69x112x40mm ITX Loop

Barrow SPD10-T DC12V 10W PWM Integrated Pump and Reservoir Combo, 450L/H Flow, 3m Head, G1/4 Ports, 69x112x40mm ITX Loop

TL;DR: The SPD10-T merges a DC12V 10W PWM pump with a PMMA reservoir top into a single 69x112x40mm aluminum-housing unit for ITX and small-form-factor water cooling loops. Rated flow is 450L/H with 3m maximum head at up to 4000RPM, drawing 0.8A at full speed. Two G1/4 ports handle inlet and outlet, and a...

Common Applications

The SPD10-T merges a DC12V 10W PWM pump with a PMMA reservoir top into a single 69x112x40mm aluminum-housing unit for ITX and small-form-factor water cooling loops. Rated flow is 450L/H with 3m maximum head at up to 4000RPM, drawing 0.8A at full speed. Two G1/4 ports handle inlet and outlet, and a PWM signal lead with a manual speed knob gives both motherboard control and standalone adjustment. Rated noise stays under 50dB, coolant temperature should remain at or below 60C, and the bearing is rated for over 50,000 hours of service.

Frequently Asked Questions

Q: What flow and head does the SPD10-T produce?

A: Maximum flow rate is 450L/H and maximum head is 3 meters at up to 4000RPM.

Q: How is the pump powered and controlled?

A: DC12V input at 0.8A rated current. Speed is controlled by motherboard PWM signal and a manual potentiometer for fixed-speed operation.

Q: What thread and dimensions does the unit use?

A: G1/4 ports for inlet and outlet. Overall size is 69mm x 112mm x 40mm, sized for ITX and SFF chassis pump brackets.

Q: What materials are used in the construction?

A: Aluminum housing around the pump body and a PMMA acrylic reservoir top.

Q: Are there coolant or fluid restrictions?

A: Operating coolant temperature should not exceed 60C. Avoid coolants containing glitter or suspended particles, which can damage the bearing.