Barrow
Barrow TDWT90-B01 G1/4 90 Degree Male-to-Female Brass Rotary Elbow Fitting
Barrow TDWT90-B01 G1/4 90 Degree Male-to-Female Brass Rotary Elbow Fitting
TL;DR: The TDWT90-B01 is a G1/4 90 degree male-to-female rotary elbow used to turn tubing direction by a right angle directly off a water block, radiator port, pump top, reservoir or distribution plate. The body is brass with an electroplated finish; an internal O-ring at the male thread seals into the...
Common Applications
The TDWT90-B01 is a G1/4 90 degree male-to-female rotary elbow used to turn tubing direction by a right angle directly off a water block, radiator port, pump top, reservoir or distribution plate. The body is brass with an electroplated finish; an internal O-ring at the male thread seals into the host port without tape, and the female spout rotates a full 360 degrees on its own O-ring so the outgoing fitting can be aimed at any angle after installation. The fitting is suited to tight clearance routing where the next port or radiator is too close to allow a straight extender plus a bend in the tube.
Frequently Asked Questions
Q: What is the angle of the adapter?
A: A fixed 90 degrees between the male G1/4 inlet and the female G1/4 outlet.
Q: Does the elbow rotate?
A: Yes. The female spout rotates a full 360 degrees against the male body on an internal O-ring, so the outgoing port can be pointed in any direction after the fitting is tightened.
Q: What is it made of?
A: Brass with an electroplated finish. Standard finishes include black and silver.
Q: Do I need PTFE tape?
A: No. A captive O-ring at the male thread makes the seal into the host G1/4 port. PTFE tape is not required.
Q: Can two of these be stacked for a U-turn?
A: Yes. Two TDWT90-B01 fittings joined male-to-female form a 180 degree return loop, useful for routing back along a radiator or a distribution plate when there is no room for a tube bend.
