Bykski B-VGA-RET-FEMINI-X Clear PMMA Low-Profile Mini Connection Upgrade Bridge for Bykski GPU Water Blocks

Bykski B-VGA-RET-FEMINI-X Clear PMMA Low-Profile Mini Connection Upgrade Bridge for Bykski GPU Water Blocks

TL;DR: The B-VGA-RET-FEMINI-X is a clear PMMA low-profile connection upgrade that replaces the stock inlet/outlet block on compatible Bykski GPU water blocks. It is designed for builds where vertical clearance above the card is tight, such as ITX cases or full-cover loops with overhead radiators, and...

Common Applications

The B-VGA-RET-FEMINI-X is a clear PMMA low-profile connection upgrade that replaces the stock inlet/outlet block on compatible Bykski GPU water blocks. It is designed for builds where vertical clearance above the card is tight, such as ITX cases or full-cover loops with overhead radiators, and provides extra room to route soft or hard tubing without bending fittings tightly against the side panel. The upgrade reuses the GPU block's existing port pattern so installation is a direct swap of the original bridge, and the clear acrylic shows coolant flow through the GPU section.

Frequently Asked Questions

Q: Which GPU blocks is this bridge compatible with?

A: Bykski GPU water blocks that use the modular Mini / RET bridge interface. Check that your specific block model lists this upgrade as compatible.

Q: Does it accept standard G1/4 fittings?

A: Yes. The two ports on the bridge are G1/4 threaded for any standard fitting.

Q: What is it made of?

A: PMMA (clear acrylic), so coolant flow through the block is visible.

Q: Why would I install it instead of the stock bridge?

A: It is lower profile than the stock inlet/outlet block, freeing vertical space above the GPU for tubing routing in tight cases.

Q: Is hardware included to mount it?

A: The package contains the bridge only. Reuse the original mounting screws and seal from the GPU water block.