Bykski
Bykski A-MS7900XTXTRIO-X Full-Cover GPU Water Block + Backplate for MSI RX 7900 XTX Gaming Trio Classic 24G, G1/4, 5V A-RGB
Bykski A-MS7900XTXTRIO-X Full-Cover GPU Water Block + Backplate for MSI RX 7900 XTX Gaming Trio Classic 24G, G1/4, 5V A-RGB
TL;DR: The A-MS7900XTXTRIO-X is engineered around the PCB of the MSI Radeon RX 7900 XTX Gaming Trio Classic 24G. It places a nickel-electroplated high-purity copper cold plate directly over the Navi 31 GPU die, GDDR6 memory packages, and VRM phases in a single full-cover assembly. The clear PMMA top is...
Common Applications
The A-MS7900XTXTRIO-X is engineered around the PCB of the MSI Radeon RX 7900 XTX Gaming Trio Classic 24G. It places a nickel-electroplated high-purity copper cold plate directly over the Navi 31 GPU die, GDDR6 memory packages, and VRM phases in a single full-cover assembly. The clear PMMA top is paired with a black anodized aluminum backplate that stiffens the card and isolates rear-side heat. Dual G1/4 inlet/outlet pairs allow either serial or parallel routing in multi-block loops, and a high-flow internal geometry keeps restriction low when chaining cards. A pre-installed 5V 3-pin addressable RGB strip is included for motherboard sync.
Frequently Asked Questions
Q: Which graphics card does the A-MS7900XTXTRIO-X fit?
A: MSI Radeon RX 7900 XTX Gaming Trio Classic 24G only. The block is matched to that specific PCB; do not install on Gaming X Trio, MECH, or other RX 7900 variants.
Q: What materials contact the coolant?
A: Nickel-electroplated high-purity copper cold plate with a PMMA acrylic top. The black anodized aluminum backplate is not in the wet path, so the loop itself stays copper-compatible.
Q: What port size, fittings, and RGB standard does it use?
A: Four G1/4 ports (top and bottom pairs) for serial or parallel chaining, and a pre-installed 5V 3-pin A-RGB (RBW) strip. Do not connect to a 12V 4-pin RGB header or the strip will be destroyed.
Q: What is in the box?
A: GPU water block with installed A-RGB strip, anodized aluminum backplate, mounting screws and standoffs, thermal pads, thermal paste, plug fittings, and an installation screwdriver.
Q: Are aluminum radiators safe with this block?
A: No. The wet path is copper, so the rest of the loop must also be copper or brass. Mixing aluminum radiators or fittings will trigger galvanic corrosion and rapid pitting.
